Maintenance And Repair; Battery Replacement - Amprobe MT-10 Mode D'emploi

5
1.800.561.8187

MAINTENANCE AND REPAIR

If there appears to be a malfunction during the
operation of the meter, the following steps should be
performed in order to isolate the cause of the problem.
1. Check the battery. Replace the battery
immediately when the " " symbol appears on
the LCD.
2. Review the operating instructions for possible
mistakes in operating procedure.
Except for the replacement of the battery, repair of the
meter should be performed only by a Factory Authorized
Service Center or by other qualified instrument service
personnel. The front panel and case can be cleaned with
a mild solution of detergent and water. Apply sparingly
with a soft cloth and allow to dry completely before
using. Do not use aromatic hydrocarbons or chlorinated
solvents for cleaning.

BATTERY REPLACEMENT

Requires one standard 9V battery. Battery compartment
is located on the bottom of the meter
1. Lift clip to access the battery compartment.
2. Connect a new 9V battery.
3. Replace the cover and securely snap in place. The
meter is now ready for use.
6
www. .com
information@itm.com