Commissioning - Sime ECOMAXI 160ErP Mode D'emploi

Installation, use and maintenance manual
6

COMMISSIONING

WARNING: check that the appliance has
been connected to the earth wire.
WARNING: check that the mains voltage
corresponds to the voltage shown on the
appliance data plate.
To commission the appliance, proceed as follows:
 Fill the boiler using the inlet valve and check
that there is no leakage from the gaskets and
connectors. Tighten the bolts or connectors
where necessary;
 Do not exceed
specified under "general technical data";
 Check that the safety devices in the hydraulic
circuit are functioning;
 Connect the plug to the power socket;
 When the plug is plugged in, the boiler is in
stand-by mode, the display is off and the ON
button lights up;
 Press the ON button (see section 7.1.3) and the
appliance is activated in ECO mode (factory
default), 5 minutes after the button has been
pressed.
the maximum pressure
MANUAL CODE: 6328407
Page 56 / 148