Unitron uTV 2 Manuel D'utilisation page 18

Cause
I cannot hear the sound from the TV via the uDirect 2
Devices not on
Cables not plugged
in correctly
No audio input to uTV 2,
the light indicator blinks
green
uTV 2 is in pause
mode
Distance between
uDirect 2 and uTV 2
is too far
28
Possible remedy
Turn all devices on
Repeat step 2
Make sure TV is not muted
Select a 75% volume level
on the TV
Make sure the audio cable
uses an "out" port
Indicated by blue blinking
status lights on both devices.
A short press of the uDirect 2
access ( ) button will un-
pause and resume
Bring devices closer to each
other, 30 m (100 ft) is the
maximum in line of sight
To avoid streaming
interruptions, make sure you
wear uDirect 2 correctly and
keep the uTV 2 within the
operating range
Cause
Volume during streaming is not comfortable
(too low or too high)
TV audio sources
have different
output volumes
After connecting the uTV 2, the TV loudspeaker is
switched off
The headset output
connection of the
TV is selected
Possible remedy
If uTV 2 is connected to the
RCA/Cinch or the SCART
socket of your TV, adjust the
volume by using the uTV 2
volume buttons
If the uTV 2 is connected to
the headset output of the TV,
you alternatively may adjust
the volume using the TV
volume control
Adjust volume of your
satellite receiver or settop
box
Adjust the volume using the
uDirect 2 volume buttons
Choose another audio output
on your TV such as RCA/
Cinch or SCART
29