Scheppach DS930 Traduction De La Notice Originale page 18

7. Do not put aside the power tool until the insertion
tool has come to a complete halt.
Attaching/changing the sanding head
(Fig.12/13)
Before performing any work on the electric power tool,
pull out the main plug.
To attach:
1. Press the lock button on the side of the tool;
2. Put the tool on the sanding head and rotate to get the
correct position
3. Release the lock button to engage.
To change: Press the lock button on the tool change
head and remove sanding head. The triangular sanding
head is attached/changed in the same way. When atta-
ching the tool change head, ensure that the locks enga-
ge correctly.
Maintenance
m Warning! Prior to any adjustment, maintenance or
service work disconnect the mains power plug!
General maintenance measures
• Keep all safety devices, air vents and the motor hous-
ing free of dirt and dust as far as possible. Wipe the
equipment with a clean cloth or blow it down with com-
pressed air at low pressure.
• We recommend that you clean the equipment imme-
diately after you use it.
• Clean the equipment regularly with a damp cloth and
some soft soap. Do not use cleaning agents or sol-
vents; these may be aggressive to the plastic parts in
the equipment. Ensure that no water can get into the
interior of the equipment.
Brush inspection
In case of excessive sparking, have the carbon brushes
checked only by a qualified electrician. Important. The
carbon brushes should not be replaced by anyone but a
qualified electrician.
Storage
Store the device and its accessories in a dark, dry and
frost-proof place that is inaccessible to children. The
optimum storage temperature is between 5 and 30˚C.
Store the electrical tool in its original packaging.
Cover the electrical tool in order to protect it from dust
and moisture.
Store the operating manual with the electrical tool.
18 І 72
 www.scheppach.com  service@scheppach.com  +(49)-08223-4002-99  +(49)-08223-4002-58