Cutting Means Engage And Disengage Functions; Reverse Gear Cutting Consent Button; Cutting Height Adjuster Lever; Acoustic Alarm Indicator Light And Device (For Rear Collection Models Only) - ST. SpA MP 84 Série Manuel D'utilisation

5.8 CUTTING MEANS ENGAGE AND
DISENGAGE FUNCTIONS
The mushroom switch allows you to
engage the cutting means using an
electromagnetic clutch (fig. 10.B):
1. Cutting means engaged.
Mushroom switch pulled
2. Cutting means disengaged.
Mushroom switch engaged.
• On disengaging the cutting
means, a brake is simultaneously
activated which stops their
rotation within a few seconds.
NOTE If you engage the cutting means
without taking the necessary safety
precautions, the engine shuts down and
cannot be restarted (see par. 6.2.2)
5.9 REVERSE GEAR CUTTING
CONSENT BUTTON
By pressing and holding this button (fig.
10.F), it is possible to switch to reverse
gear with the cutting means engaged
without causing the engine to stop.

5.10 CUTTING HEIGHT ADJUSTER LEVER

Use this lever to raise and lower the
cutting-means assembly to one of the 7
different cutting heights (fig. 10.G).
The seven positions for this lever,
shown as «1» to «7» on the label,
correspond to various cutting
heights between 3 and 8 cm.
To go from one position to another,
move the lever sideways and put it
back in one of the stop notches.
5.11 ACOUSTIC ALARM INDICATOR
LIGHT AND DEVICE (FOR REAR
COLLECTION MODELS ONLY)
• This light (fig. 10.C) comes on when the
key (fig. 10.A) is in the "ON" position and
stays on while the machine is running.
• When it flashes, it means that it is not
ready to be started (see par. 6.2.2).
• The sound warning signals that the
grass catcher is full (see par. 6.5.5).
5.12 GRASS CATCHER TIPPING
LEVER (IF FORESEEN, FOR REAR
COLLECTION MODELS ONLY)
This pull-out lever tips and empties
the grass catcher. This means less
work for the operator (fig. 10.H).

6. USING THE MACHINE

The safety regulations to follow
are described in chap. 2. Strictly
comply with these instructions to
avoid serious risks or hazards.

6.1 PREPARATION

Before starting to mow, it is necessary to carry
out several checks and operations to ensure you
can work efficiently and in maximum safety.
6.1.1 Filling with oil and fuel
IMPORTANT The machine is
supplied without engine oil or fuel.
Before using the machine check for fuel and
the oil level (par. 7.2, par. 7.3). For refuelling
and oil top-up methods and precautionsent
follow the instructions given in (par. 7.2,
par. 7.3) and in the engine handbook.
6.1.2 Seat adjustment
To change the seat position, loosen the four
fixing bolts (fig. 11.A) and slide it along the
slots. Once you have found the right position,
tighten the four screws (fig. 11.A) thoroughly.
6.1.3 Tyre pressure
Having the right tyre pressure is the main
condition for ensuring that the cutting-means
assembly is horizontal and mows evenly.
1. Unscrew the valve caps
2. Connect a compressed air line with
a gauge to the valves (fig. 12)
3. Adjust the pressure according to the values
indicated in the "Technical Data" chart.
EN - 10