After Operation; Routine Maintenance; General Information; Refuelling / Emptying The Fuel Tank - ST. SpA MP 84 Série Manuel D'utilisation

6.7 AFTER OPERATION

1. Allow the engine to cool before
storing in an enclosed space.
2. Clean (par. 7.4).
3. Lower the cutting-means assembly, shift
to neutral, engage the parking brake,
turn off the engine and remove the
ignition key (checking that all moving
parts are completely stationary):
– whenever the machine is left unattended,
the operator dismounts from the
driving seat, or parks the machine;

7. ROUTINE MAINTENANCE

7.1

GENERAL INFORMATION

The safety regulations to follow
are described in chap. 2. Strictly
comply with these instructions to
avoid serious risks or hazards.
Before conducting any inspections,
cleaning or maintenance/adjustment
interventions on the machine:
• disengage the cutting means;
• shift into neutral;
• engage the parking brake;
• stop the engine;
• remove the key, (never leave the
keys in the ignition or within reach of
children or unauthorised persons);
• make sure that all moving parts
have come to a complete stop;
• read the relevant instructions;
• Use suitable clothing, protective
gloves and goggles
• The frequency and types of maintenance are
summarised in the "Maintenance Table". The
table will help you maintain your machine's
safety and performance. It lists the main
maintenance tasks and how often they need
to be performed. Carry out the relevant task
as soon as it is scheduled to be performed.
• The use of non-genuine and/or incorrectly
assembled spare parts and attachments
could adversely affect machine operation
and safety. The manufacturer shall
decline all liability in the event of injuries
or damages caused by such parts.
• Genuine spare parts are supplied by
authorized assistance workshops and dealers.
7.2 REFUELLING / EMPTYING
THE FUEL TANK
NOTE The type of fuel to use is
given in the engine manual.
IMPORTANT The machine is delivered
to the client without fuel. Follow all the
instructions in the engine manual.
7.2.1 Refuelling
To refuel:
1. Unscrew the tank closure cap
and remove it (fig. 24).
2. Insert the funnel (fig. 24).
3. Refuel being careful not to
completely fill the tank.
4. Remove the funnel.
5. Close the fuel cap securely after
refuelling and clean away any spills.
IMPORTANT Do not drip petrol onto
the plastic parts to avoid ruining them.
In the event of accidental leaks, rinse
immediately with water. The warranty does
not cover for damage to plastic parts of the
bodywork or the engine caused by petrol.
7.2.2 Emptying the fuel tank
NOTE Fuel is perishable and should
not remain in the tank for more than 30
days. Empty the fuel tank before storing the
machine for long periods of time (chap. 9).
Allow the engine to cool
before emptying the fuel tank.
1. Place the machine on a flat
surface, in the open air.
2. Place a suitable container under
the drain tube (fig. 26.A).
3. Disconnect the tube (fig. 26.A) installed
on the fuel filter inlet (fig. 26.B).
4. Open the fuel tap (if provided)
5. Collect the fuel in a suitable container.
6. Reconnect the tube (fig. 26.A) making sure
you position the clamp properly (fig. 26.C).
7. Close the fuel tap (if provided).
The next time the machine is used,
check that there are no fuel leaks from
the tubes, fuel stopcock or carburettor.
EN - 15