Starting The Light Function From The Remote Control - Teuco S01 Manuel De L'utilisateur

STARTING THE LIGHT FUNCTION FROM THE REMOTE CONTROL

- Pressing the LIGHT button will switch
on the light source in the tub.
- To change the user configuration, press
the CHANGE button so that you can
select the light source to use.
- Selecting the chromo therapy function
will cause the spot to switch on and rotate
the colours in the following sequence:
White -Pink - Red - Orange - Yellow -
Green - Cyan - Blue - Purple.
- Pressing the light key twice turns off the
light sources of the tub.
- When there is a single light source, the
LIGHT button will switch this off or on.
IT IS NOT POSSIBLE TO SET THE COLOUR OF THE TUB LIGHTING FROM THE REMOTE CONTROL.
DO NOT USE THE CHANGE KEY TO SELECT THE LIGHT SOURCE AT THE SAME TIME AS MAKING SOUND AND
MASSAGE SELECTIONS.
THE 0/I BUTTON INSTANTLY STOPS ALL ACTIVE FUNCTIONS, SETTING THE SYSTEM TO STAND BY.
ACCESSING THE INFO MENU WILL DEACTIVATE THE REMOTE CONTROL.
WHEN THERE IS A SINGLE LIGHT SOURCE, THE CHANGE BUTTON CANNOT BE USED AND THE CONTROL
PANEL WILL DISPLAY "NOT AVAILABLE" FOR 2 SECONDS.
IF THERE IS NO COLOUR CHANGE FUNCTION, THE RIGHT AND LEFT BUTTONS CANNOT BE USED AND THE
CONTROL PANEL WILL DISPLAY "NOT AVAILABLE" FOR 2 SECONDS.
IF THERE IS AN ATTEMPT TO ACTIVATE A FUNCTION NOT FOUND ON THE PRODUCT, THE CONTROL PANEL
WILL DISPLAY "NOT AVAILABLE" FOR 2 SECONDS.
INSTRUCTIONS FOR USE
ACCESSORY FUNCTIONS
X2
EN
5