Automatic Filling - Teuco S01 Manuel De L'utilisateur

EN INSTRUCTIONS FOR USE
STARTING THE SYSTEM
The automatic filling function is both unique and innovative: it makes preparing the tub a relaxing and
immediate process, so that you only spend time enjoying its use. Water dispensing is activated from the
control panel and stops when the tub is full and the temperature is as preset by the user.
- From READY MENU select the
AUTOMATIC FILLING icon, using the
arrows to move the cursor and pressing
OK to confirm.
- The AUTOMATIC FILLING mode will
start.
- Set the desired temperature value (min.
15°C – max. 40°C) for the first filling of
the tub and successive topping up of the
tub using the UP and DOWN keys.
- Press OK to confirm.
- If no buttons are pressed for 15 seconds
the panel will return to READY MENU
mode.
- To cancel the operation, press EXIT.
- The flashing icon shows that the function
is active and the panel will read H2O.
- Once the correct level has been reached,
the panel will display the temperature of
the water in the tub.
- To stop the function beforehand, select
the AUTOMATIC FILLING icon using the
arrows to move the cursor and press OK
to stop.
- The display will return to the MAIN
MENU.
IT IS ADVISABLE TO KEEP THE AUTOMATIC FILLING FUNCTION SWITCHED ON (FLASHING ICON). THE TUB WILL AUTOMATICALLY
TOP UP THE WATER LEVEL. THIS FUNCTION IS NOT OPERATIVE ON CERTAIN VERSIONS, THEREFORE ACTIVATE THE
"AUTOMATIC FILLING" FUNCTION MANUALLY.
IF THE NECESSARY LEVEL FOR OPERATION IS NOT REACHED AFTER 60 MINUTES, THE WATER DISPENSING FUNCTION WILL
LOCK AND THE DISPLAY WILL READ "!".(SEE ALARMS SECTION).
DO NOT USE THE TUB/POOL BEFORE THE AUTOMATIC FILLING PROCEDURE HAS BEEN COMPLETED - THE DISPENSER
OPENING MAY STILL POUR EXTREMELY HOT WATER INTO THE TUB (WITH RISK OF SCALDING AS A RESULT).
A PERSON INSIDE THE TUB DURING THE AUTOMATIC FILLING PROCESS MEANS THAT THE TUB/POOL CANNOT BE FILLED
WITH THE AMOUNT OF WATER REQUIRED FOR ITS CORRECT OPERATION.
12

AUTOMATIC FILLING

15sec.