Connection Of The Audio Source (Bluetooth®); Requirements Of The Source Devices; Technical Characteristics - Teuco S01 Manuel De L'utilisateur

CONNECTION OF THE AUDIO SOURCE (BLUETOOTH®)
Follow these steps to carry out the Bluetooth® audio connection between the amplifier and an audio
source equipped with a Bluetooth® A2DP transmission signal:
- Switch on the amplifier (with the loudspeakers connected).
- Switch on the source device and activate the Bluetooth® function.
- If a connection confirmation is requested, digit the pairing code: 0000.
- Play an audio track via the player of the source device.
In the case of source devices such as mobile phones, it is necessary to carry out the synchronisation of
the Bluetooth® devices utilising the device research function.
For further information, refer to the instruction manual of your telephone.

REQUIREMENTS OF THE SOURCE DEVICES:

To function correctly with the amplifier, the source device must have the following characteristics:
- Communication protocol: Bluetooth® 2.1 or previous.
- Profiles: A2DP, AVRCP.
- Band frequency: 2.4 GHz.
- Range: Class 2 - 10m.
- Audio volume control.

TECHNICAL CHARACTERISTICS:

Power source
Power source protection fuse
Nominal power output (Left/Right)
Subwoofer nominal power output
Frequency response
Operating temperature range
Operating temperature range
Bluetooth® Protocol
Profiles
Range
Pairing code
TECHNICAL CHARACTERISTICS
230Vac 50/60Hz
Fuse 5x20, 400 maT 250V
10+10 Wrms at 4ohm
20 Wrms at 4ohm
80-20000 Hz
-10/+50 °C
-10/+70 °C
Bluetooth® SPECIFICATIONS
2.1
A2DP, AVRCP
Class 2 - 10m/33ft
0000
INSTRUCTIONS FOR USE
SOUND FUNCTIONS
EN
19