Hayward SALT & SWIM 3C Guide De L'utilisateur page 15

4. INADEQUATE WATER FLOW LED illuminated
The Salt & Swim 3C has sensed a low flow or no flow condition and has stopped generating chlorine.
- Verify that the filter pump is running and there are no obstructions or restrictions in the pool plumbing.
- Backwash the pool filter.
- Increase the speed of your variable speed pump
If the condition persists, remove the Cell from the Vessel and check that the flow switch is free to move in both directions.
Refer to the diagram below.
5. CELL LIFE LOW LED illuminated
The Cell has reached the end of its life. Replace as soon as possible
6. PROBLEM DETECTED LED illuminated AND a DAILY CHLORINE OUTPUT LED is blinking
The Salt & Swim 3C may display an error by illuminating the PROBLEM DETECTED LED and blinking one of the DAILY
CHLORINE OUTPUT LEDs. There are ten DAILY CHLORINE OUTPUT LEDs that each indicate a different error.
These LEDs are labeled with a number on the diagram below. Refer to the table for their corresponding errors.
7. PROBLEM DETECTED LED illuminated AND MAX LED blinking
There is a communication error with the Cell. Check that the Cell cap is properly plugged in and that the wire to the
Control Box is not cut or damaged.
8. PROBLEM DETECTED LED illuminated AND MIN LED blinking
- The salt level may be too low. Adjust salt to recommended levels.
- Remove and inspect the Cell for scale. If the Cell is scaled, follow the directions on "Servicing and Cleaning the
Salt & Swim 3C Cell" chapter.
9. PROBLEM DETECTED LED illuminated AND 20% LED blinking
Salt level is too high. Test the salt level and adjust to the recommended levels.
Page 15
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
Salt & Swim™ 3C