Hayward SALT & SWIM 3C Guide De L'utilisateur page 6

With power removed to the pump and water drained from the pool plumbing, secure the Cutting Template to the location
where the Cell Vessel will be installed. Note that the Cutting Template is the same width as the Cell Vessel. The entire
Cutting Template must fit on the pipe otherwise the Cell Vessel will not fit. With the Cutting Template secure on the pipe,
mark all 10 cutouts on to the pipe using a waterproof permanent marker.
Filter
pump
Remove the Template, cut the pipe and install the Nut Assemblies as shown below. Use the included 63 mm (2 in) Nut
Assembly for 63 mm (2 in) pipe and 50 mm (1.5 in) Nut Assembly for 50 mm (1.5 in) pipe. Place Nut Assembly on each side
of the cut pipe (threads face in). Be sure to place the Nut, Compression Ring and Collar on the pipe as shown in the diagram.
Page 6
Filter Solar
System
From Pool
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
Salt & Swim™ 3C
Heater
The Cutting Template is the same length as
the installed Vessel. Make sure that the entire
Cutting Template Fits at the desired location.
Secure the Template and mark all of the
cutouts.
Cutting
Template
To Pool
Cutting Template
Mark Pipe
Cut Pipe and
Clean Shavings
Slide Nuts
on Pipe
Slide Compression
Rings over marks
Slide Collars
on pipe
Permanent
Marker
Mark all
10 cutouts