Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
3. Turn the filter pump ON. Make sure that full flow is achieved (no air in the system) and run the pump for at least 15
seconds.
4. Turn the filter pump OFF.
5. The Salt & Swim 3C should now display a solid INADEQUATE WATER FLOW and a solid STANDING BY LED. The Flow
Switch Calibration procedure is complete. You can now turn on your filter pump and begin normal operation.
If the INADEQUATE WATER FLOW LED is still blinking after performing this procedure, refer to the Troubleshooting section
of this manual.
Water Chemistry
The table below summarizes the levels that are recommended by Hayward. The only special requirements for the Salt &
Swim 3C are the salt level and stabilizer. It is important to maintain these levels in order to prevent corrosion or scaling and
to ensure maximum enjoyment of the pool. Test your water periodically. Your authorized Salt & Swim 3C dealer or most pool
stores can provide you with the chemicals and procedures to adjust the water chemistry. Be sure to tell the pool store that
you are using a Salt & Swim 3C chlorine generator.
Saturation index
The saturation index (Si) relates to the calcium and alkalinity in the water and is an indicator of the pool water "balance".
Your water is properly balanced if the Si is 0 ±.2. If the Si is below -0.2, the water is corrosive and plaster pool walls will
be dissolved into the water. If the Si is above +0.2, scaling and staining will occur. Use the chart below to determine the
saturation index.
Page 9
CHEMICAL
Salt
Free Chlorine
pH
Cyanuric Acid
(Stabilizer)
Total Alkalinity
Calcium Hardness
Metals
Saturation Index
Si = pH + Ti + Ci + Ai - 12.1
°C
°F
12
53
16
60
19
66
24
76
29
84
34
94
39
100
How to use: Measure pool pH, temperature, calcium hardness, and
total alkalinity. Use the chart above to determine Ti, Ci and Ai into the
above equation. If Si equals 0.2 or more, scaling and staining may
occur. If Si equals -0.2 or less corrosion or irritation may occur.
CORROSIVE
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
Salt & Swim™ 3C
IDEAL LEVELS
2.7 to 3.4 g/l
1.0 to 3.0 ppm
7.2 to 7.8
20 to 30 ppm (25 ppm best)
Add stabilizer only if necessary
80 to 120 ppm
200 to 300 ppm
0 ppm
-.2 to .2 (0 best)
Calcium
Total
Ti
Ci
Hardness
Alkalinity
0.3
75
1.5
75
100
1.6
100
0.4
1.7
125
125
0.5
150
1.8
150
200
1.9
200
0.6
250
2.0
250
0.7
300
2.1
300
2.2
400
400
0.8
600
2.4
600
0.9
800
2.5
800
0
0.2
- 0.2
SCALING
OK
Ai
1.9
2.0
2.1
2.2
2.3
2.4
2.5
2.6
2.8
2.9
Publicité
Table des Matières
