IKEA KONSISTENS Mode D'emploi page 26

CarE aND CLEaNING
removing and replacing the Oven
Door
CaUTION
The door is heavy. To temporarily store it safely,
place the door horizontally with the interior side
facing down.
IMpOrTaNT
Special door care instructions - The door is heavy.
For safe, temporary storage, lay the door flat with
the inside of the door facing down. Most oven
doors contain glass that can break. Do not close
the oven door until all the oven racks are posi-
tioned correctly in the cavity. Do not hit the glass
with bakeware or any other objects. Scratching,
hitting, jarring, or stressing the glass may weaken
its structure, causing an increased risk of breakage
at a later time.
To remove the oven door:
1. Open oven door completely, horizontal with floor.
2. Pull up the lock located on each hinge support
toward front of the oven until the lock stops. You
may have to apply a little upward pressure on
the lock to pull it up (Figure 8).
3. Grasp the door by the sides, and close the door
until the door frame makes contact with the
unlocked hinges. (Figure 9)
4. Pull the bottom of the door toward you while
rotating the top of the door toward the appliance
to completely disengage the hinge levers (Figure
10).
To replace Oven Door:
1. Firmly grasp both sides of oven door along the
door sides. Do not use the oven door handle
(Figure Figure 9).
2. Hold the oven door at the same angle as the
removal position. Carefully insert the hinge
levers into the oven frame until you feel the
hinge levers are seated into the hinge notches.
The hinge arms must be fully seated into the
hinge notches before the oven door can be fully
opened. (Figure 10).
3. Fully open the oven door, horizontal with floor.
4. Push the door hinge locks up toward and into
the oven frame on both left and right oven door
hinges to the locked position (Figure 8).
5. Close the oven door.
26
Figure 7: Door hinge location.
Figure 8: Unlocking and locking door hinges
oven
door
Figure 9: remove door position
roller
pin
hinge
arm
Figure 10: removing and replacing over-
hinge supports
EN
Oven door
hinge
locations
about
10°
hinge