Preparing The Flash Unit For Use; Mounting The Flash Unit - Metz mecablitz 52 AF-1 Nikon digital Mode D'emploi

• Programmed auto flash mode
• Preflash for red-eye reduction
• Wireless remote flash mode (Advanced
• Servo mode
• Spot zoom mode
• Wake-up function for the flash unit
• Firmware updates
+
It is impossible to describe all camera types
and their individual dedicated flash func-
tions within the scope of these instructions.
Therefore, please refer to the flash mode
description in your camera's operating
instructions to find out which functions are
supported and which ones have to be set
k
manually on the camera.
Using lenses not equipped with a CPU (i.e.,
lenses without auto focus mode), results in
certain functional limitations!
144
Wireless Remote Flash Mode Lighting)
1) not with Coolpix cameras

3 Preparing the flash unit for use

3.1 Mounting the flash unit

Mounting the flash unit on the camera
+
Turn off the camera and flash before moun-
ting or removing.
• Turn the knurled nut
unit housing as far as it will go. The locking
pin in the adapter shoe is now fully
retracted into the case.
• Slide the flash unit foot completely into the
camera accessory shoe.
• Turn the knurled nut
housing as far as it will go, clamping the
flash unit in place. If the camera does not
have a locking hole, the spring-loaded
locking pin retracts into the adapter case
so as not to damage the surface.
Removing the flash unit from the camera
+
Turn off the camera and flash before moun-
ting or dismounting.
• Turn the knurled nut
unit housing as far as it will go.
• Remove the flash unit from the camera's
accessory shoe.
towards the flash
towards the camera
towards the flash