Pressure Measurement Port; Operation; Applying The Mask; Adjusting The Mask - Weinmann JOYCEeasy Mode D'emploi

Operation

3.5 Pressure measurement
port
The mask has a connection 8 which can be
used for measuring pressure or supplying
oxygen. If you are not using the pressure
measurement port, close it with the plug 7
to reach therapy pressure.
4 Operation

4.1 Applying the mask

1. Pull the headgear 1 over the head and
place the mask on the face (figure B1).
2. Insert headgear clips 11 (figure B2).

4.2 Adjusting the mask

1. Undo lock 4 (figure C1).
2. Pull the forehead support 3 in or out of
the lock 4 bit by bit as necessary (figure
C1).
Remember the most convenient
position. To do this, use the scale
between the forehead support and the
lock (figure C1).
3. Applying the mask
the mask", page 18).
4. Adjust headgear 1 with the aid of the
hook-and-loop fasteners so that the
mask seals on the face but is not too
tight (figure C2).
18 EN JOYCEeasy
(see "4.1 Applying
5. To adjust the hook-and-loop fastener on
top of the head undo the hook-and-
loop fastener, pull on the ends of the
headgear with both hands and close the
fastener again (figure C3).

4.3 Removing the mask

1. Undo 11 the headgear clips.
2. Slip the headgear 1 over the head and
remove the mask.

4.4 Dismantling the mask

1. Undo the headgear clips 11 (figure D1).
2. Release hook-and-loop fasteners from
headgear clips 11 and forehead
support 3 and remove the headgear 1
(figure D1 + D2).
3. Remove the plug for the pressure
measurement port 7 (figure D3).
4. Remove forehead cushion 2 from
forehead support 3 (figure D4).
5. Take mask cushion 12 off mask body 10
(figure D5).
6. Turn retaining ring 5 counterclockwise
and remove it (figure D6).
7. Remove elbow 6 from retaining ring 5
(figure D7).
8. Take rotating sleeve 9 off elbow 6
(figure D7).