Tips; Change Of Patient; Disposal - Weinmann JOYCEeasy Mode D'emploi

Disposal

2. Clean mask in accordance with the table
below:
Action
Wash mask components with
warm water and a mild
detergent.
When washing mask parts
(exception: mask cushion,
anti-asphyxia valve and
forehead cushion), clean
thoroughly with a cloth or a
soft brush.
Wash headgear by hand.
3. Rinse all parts with clear water.
Material damage due to abrasion!
Rubbing the mask cushion and forehead
cushion can damage the coating.
 Do not rub the mask cushion and
forehead cushion dry.
Material damage due to careless use!
Careless handling can damage the anti-
asphyxia valve.
 Always handle the anti-asphyxia valve
with care.
4. Allow all parts to air-dry.
5. Perform a visual inspection.
6. Replace damaged parts if necessary.
7. Assembling the mask
Assembling the mask",
20 EN JOYCEeasy
X
X
X
(see "4.5
page 19).
Discolorations of mask components do
not impair the functionality of the mask.

5.2 Tips

• You can wash all parts (exception: anti-
asphyxia valve and headgear) in a
dishwasher at 65 °C.
• Do not dry parts in direct sunlight.
• Wash headgear before first use, as the
color may run.
• Do not iron the headgear in order to
keep the hook-and-loop fasteners
intact.
• Do not dry the headgear in a tumble-
dryer.

5.3 Change of patient

You must subject the mask to a hygiene
preparation in the event of a change of
patient. For information on hygiene
preparation in the event of a change of
patient, please refer to our internet
brochure at www.weinmann.de. If you do
not have Internet access, please contact
Weinmann.
6 Disposal
You can dispose of all parts in domestic
waste.