Parts And Features; Cooktop Use; Cooktop Controls - IKEA Eldig Guide D'utilisation Et D'entretien

PARTS AND FEATURES

This manual covers different models. The cooktop you have
purchased may have some or all of the items listed. The
locations and appearances of the features shown here may not
match those of your model.
Control Panel - Varies by Model
A
E
A. Surface burner locator
B. Left rear control knob
C. Right rear control knob
D. Left front control knob
E. Right front control knob
Cooktop
A B
A Model and serial number
plate
(located under cooktop)
B. Surface burner grate
4
A
B
C
D
C
D
C. Surface burner cap
D. Control panel

COOKTOP USE

B
Do not let the burner flame extend beyond the edge of
the pan.
Turn off all controls when not cooking.
C
Failure to follow these instructions can result in death
or fire.
IMPORTANT: Your cooktop is factory-set for use with Natural
gas. If you wish to use Propane gas, an Propane Gas Conversion
Kit is included with your new cooktop. See the instructions
included with the Propane Gas Conversion Kit for details on
D
making this conversion.
Electric igniters automatically light the surface burners when
control knobs are turned to LITE.
The large burners (12,000 Btu/h [British Thermal Units]) provide
the highest heat setting, and are ideal for cooking large
quantities of food or liquid, using large pots and pans. The small
E
burners (9,100 Btu/h and 6,000 Btu/h) allow more accurate
simmer control at the lowest setting, and are ideal for cooking
smaller quantities of food, using smaller pots and pans.
Before setting a control knob, place filled cookware on the grate.
Do not operate a burner while using empty cookware or without
any cookware on the grate.
NOTE: Visually check that the burner has lit. If the burner
does not ignite, listen for a clicking sound. If you do not hear
the igniter click, turn the burner off. Check for a tripped circuit
breaker or blown household fuse.
Check that the control knob is pressed completely down on
the valve shaft. If the spark igniter still does not operate, call a
trained repair specialist.
Proper grounding and polarity are necessary for correct
operation of the electric ignition system. If the wall receptacle
does not provide correct polarity, the igniter will become
grounded and occasionally click, even after the burner has
ignited. Contact a trained repair specialist to check the wall
receptacle to see whether it is wired with the correct polarity.
To Set:
1. Push in and turn knob counterclockwise to LITE.
All 4 surface burners will click. Only the burner with the
control knob turned to LITE will produce a flame.

Cooktop Controls

WARNING
Fire Hazard