Battery Maintenance; Cleaning And Disinfecting Instruction - Gima OXY-10 Mode D'emploi

29
• Please change the batteries when the low-voltage indicator lightens.
• Please clean the surface of the oximeter before use. Use soft cloth
with alcohol to wipe the oximeter first, and then let it dry in air or wipe it dry.
• Please take out the batteries if the oximeter will not be used for a long time.
• The recommended storage environment of the device:
ambient temperature: -20ºC~60ºC,
relative humidity 10%~95%,
atmospheric pressure: 50kPa~107.4kPa.
• The oximeter is calibrated in the factory before sale, there is no need
to calibrate it during its life cycle. However, if it is necessary to verify
its accuracy routinely, the user can do the verification by means of SpO
simulator, or it can be done by the local third party test house.
• Necessary servicing must be performed by qualified service engineers
ONLY. Users are not permitted to maintain it by themselves.
High-pressure sterilization cannot be used on the device.
Do not immerse the device in liquid.

6.2 Battery Maintenance

• Keep the both sides of coin cell clean.
• Low temperature may decrease the performance of coin cell, and low
battery indicator may appear early. In such case, please put coin cell into
pocket for warm before use, thus bring it back to normal condition.
• Do not let any conductive metal (such as tweezers) contact both sides
of coin cell simultaneously to avoid short circuit.
• Charge the coin cell for 8~10 hours each time; ambient temperature should
be 5~40°C.
• If the coin cell is full after charging, but its performance decreases
apparently, it means the coin cell is exhausted, please change a new one.

6.3 Cleaning and Disinfecting Instruction

• Surface-clean sensor with a soft cloth by wetting with a solution such
as 75% isopropyl alcohol, if low-level disinfection is required, use a 1:10
bleach solution.
• Then surface-clean by soft cloth wet with clean water and let air dry
or wipe it dry.
Caution: Do not sterilize by irradiation steam, or ethylene oxide.
Do not use the sensor if it is damaged.
ENGLISH
2