Clarity XLC3.4+ Guide De L'utilisateur page 10

XLC3.4+
1. Follow the instructions in the Installation section on page 6 to
remove the base and handset from the base – steps 1, 4, 6.
2. Unplug the long phone line cord from the phone jack located on
the back of your XLC3.4+. Plug one end of the short phone line
cord into the same jack identified by LINE on the back of your
base.
3. Install the XLC3.4+ base onto the wall mount bracket as shown
on page 9. Guide the short phone cord through the wall mount
bracket as shown in the diagram.
4. Using a screwdriver, loosen the screws on your phone wall outlet
(1-2 turns).
5. Plug the loose end of the short phone cord into the wall phone
outlet.
6. Attach the wall mount bracket (with the XLC3.4+ base) onto the
wall phone outlet.
7. Plug the power adapter into a wall electrical outlet.
8. Pull the handset's battery tab located on the bottom of the
device in the direction of the arrow.
9. Place the handset in the base and allow 16 hours for full charge.
8
WALL MOUNTING YOUR XLC3.4+