Technical Data - S+S Regeltechnik KYMASGARD AFTF-HK-FSE Notice D'instruction

G
®
KYMASGARD AFTF - HK - FSE
The multifunctional outside sensor KYMASGARD
Energy is generated by converting outdoor light into electric energy by means of a solar generator.
It is used to detect the outside temperature, outdoor humidity and outdoor light intensity and to transmit the measurands via radio signal to radio
actuators and radio receivers/gateways.

TECHNICAL DATA

Operation:
Radio technology:
Channels:
Radio transmitter module:
Measurand acquisition:
Transmission interval:
Range of coverage:
HUMIDIT Y
Operating range, humidity:
Deviation in humidity:
TEMPERATURE
Operating range, temperature:
Deviation in temperature:
LIGHT INTENSIT Y
Light intensity operating range:
Deviation in light intensity:
Housing:
Housing dimensions:
Protective tube:
Sensor protection:
Ambient temperature:
Storage temperature:
Permitted humidity:
Protection class:
Protection type:
Standards:
®
KYMASGARD AFTF-HK-FSE
Type ⁄ WG02 Channels
AFTF-HK-FSE
A F T F - H K- F S E 3
® AFTF-HK-FSE is a maintenance-free radio transmitter without battery for on-wall installation.
Energy generation by solar cell,
batteryless, maintenance-free
EnOcean protocol, modulation ASK, 868 MHz,
transmission power max. 10 mW, telegram type 4BS
1 temperature,
1 humidity,
1 light intensity
EnOcean Dolphin
adjustable, every 1s ⁄ 10 s ⁄ 100 s
adjustable, typically every 100 seconds, or at any measuring value change,
status telegram approximately every 16 minutes
Indoors typically 30 - 100 m, outdoors up to 300 m
0...100 % r. H.
typically ± 2.0 % (20...80 % r. H.) at +25 °C, otherwise ± 3.0 %
–20...+60 °C
typically ± 0.2 K at +25 °C
Multi-range switching 0...2000 Lux / 0...60 kLux
typically < 5 % of final value
Plastic, UV-resistant, polyamide material,
30 % glass-globe reinforced,
with quick-locking screws (slotted ⁄ Phillips head combination),
traffic white colour (similar to RAL 9016),
housing cover is transparent!
72 x 64 x 43.3 mm (Tyr 1)
made of stainless steel V2A (1.4301), Ø =16 mm, NL = 55 mm
plastic sinter filter, Ø 16 mm, L = 35 mm, exchangeable
(optional metal sinter filter, Ø 16 mm, L = 32 mm)
–25...+60 °C
–25...+60 °C
0...90 % r.H., non-precipitating air
III (according to EN 60 730)
IP 65 (according to EN 60 529) Housing tested,
TÜV SÜD, Report No. 713139052 (Tyr 1)
CE conformity according to EMC Directive 2014 ⁄ 30 ⁄ EU
and according to R&TTE Directive 2014 ⁄ 53 ⁄ EU
Outside radio sensor for humidity, temperature and light intensity
Measuring ranges
Temperature Humidity
–20...+60 °C 0...100 % r.H.
Light intensity
(switchable)
0...2000 Lux / 0...60 kLux
Rev. 2020 - V22
Item no.
1801-1 140-1000- 000