Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Installation
1.
Install the mounting brackets and burner tray cover to the
firebox as per instructions supplied with the 922 engine.
2.
Install the black canopy shield to cover the openings in the
cast iron canopy.
a)
Lay inner arch face down on the floor. Insert one corner
of the shield into the corner behind the arch's cast frame
as shown.
b)
Bend the canopy shield to a slight radius while inserting
the other corner behind the arch's cast frame as shown
(it may be necessary to loosen or remove one or two of
the canopy bolts).
c)
With both corners behind the arch's cast frame, snap the
shield forward to follow the curve of the cast iron canopy.
The top of the shield should fit under the projecting ledge
in the frame as shown.
3.
Fasten the top filler piece to the back of the outer cast arch.
4.
Mount outer cast arch to brackets on firebox as shown below.
5.
Hang the inner arch on the outer arch and install wire guard
as shown below.
9
Publicité
Table des Matières
