Connecting The Printer To The Telephone Network; Connecting To The Telephone Network And Connecting An External Telephone - Olivetti LINEA office Guide Rapide

The green USB status LED illuminates to indicate that a correct connection has been established.
If the connection is not established, make sure you have connected a compatible device.

CONNECTING THE PRINTER TO THE TELEPHONE NETWORK

Two RJ11 connectors are present on the back of the printer: "LINE" (on the right) and "EXT" (on the left). Using
the telephone cable provided, connect the telephone line to the "LINE" socket.
You can connect an external telephone or an answering device to the "EXT" socket.
If the socket is protected by a cover, remove it.
A telephone connected in a cascade can be used to make and reply to calls, and to send a START signal to receive
a fax (the default DTMF code * * can be customised by selecting Toolbox > Settings > Fax settings >
Installation > Configuration ).
In this case, the keyboard display indicates that an additional telephone is connected.

Connecting to the Telephone Network and Connecting an External Telephone

As connecting an additional telephone or other device to the fax telephone line is subject to national regulations,
which vary from country to country, the illustrations on the next pages show connection examples.
If, in the destination country, connection to the telephone line differs from those shown in the examples, refer to
the regulations in force in the destination country.
• The fax is set up to be connected to the public telephone line. To connect it to a private line and use it also on a
public line, refer to the section "Installing the Fax".
• In the case of a multiple-socket telephone system, additional telephone devices can be connected to any of
the sockets available provided that the system is of the type with multiple sockets in parallel. In this case, the
dial tone is always present when the handsets of the existing telephone devices are lifted simultaneously.
QUICK REFERENCE GUIDE 7