How To Make Copies - Olivetti COPIA 9020 Instructions D'emploi

HOW TO MAKE COPIES

CLEAR/STOP key
Press the CLEAR/STOP key (A-16) if you want to stop copying or change the number of copies set.
RESET key
To return to Standard mode, press the RESET key (A-15).
SELF-RESET FUNCTION
If no copies are made for 2 minutes, or no key is pressed, the self-reset functions will automatically return
the copier to standard mode.
STANDBY FUNCTION (Energy Saving)
To save energy when the copier is not being used, press the STANDBY key (A-32) to activate the energy
saving function (press the same key again to deactivate it).
When the function is active, all the console indicators switch off leaving only those of the STANDBY key
and the power on switch lit up.
Notes
- Switch off the copier when it is not going to be used for some time (e.g. overnight).
- When the standby function is deactivated to make copies, less warm-up timeis necessary than when
the machine has been switched off.
4
chap1.p65
1. Power On
On/off switch in "I" position.
The LED lights up and the PRINT key (A-30) flashes (green). The
copier is ready for settings and the print command.
Once the warm-up phase is over (approx. 30 s), the PRINT key led
(A-30) stays on (orange) and the copy procedure is executed
automatically (if the PRINT key (A-30) has been pressed at the
warm-up phase).
Copier power on conditions (standard mode)
Copy ratio
Exposure regulator
Paper selection
Number of copies
2. Position of the original
Lift the cover, place the original face down on the clipboard glass
aligned with the reference mark "å" on the top left corner.
3. Setting the copy mode
To change the copy parameters in Standard mode, following the
instructions in the following sections:
Setting the number of copies
Regulating the exposure
Selecting the copy format
Reductions and enlargements
4. Copying
Press the PRINT key (A-30). During copying, the key indicator
remains lit (orange).
4
1:1
automatic
automatic
1
(page 5)
(page 5)
(page 6)
(page 6)
01/02/00, 10.42