Disposal; Assistance And Warranty - Imetec F4101 Mode D'emploi

EN
The plate (14) is dirty: there are
impurities or limescale residues.
The boiler cleaning LED (6)
continues blinking even after it
has been cleaned.
The steam (ready) LED (5) does
not light up or water leaks from
the boiler cleaning cap (11).
Patches remain wet while ironing.
The iron does not stay up in
vertical position
The product is packaged in recyclable materials. Dispose of it in compliance with the
environmental protection standards.
The appliance must be disposed of in compliance with EU standard 2002/96/EC.
The recyclable materials contained in the appliance must be collected to prevent
environmental pollution. For further information contact the local waste authority or
the appliance retailer.
To request repairs or purchase spare parts please contact IMETEC's authorised customer
service centre on the Toll-Free Number below or via the website. The appliance is covered
by the manufacturer's warranty. For details, read the attached warranty sheet. Failure to
comply with the instructions for use and maintenance provided in this manual will render the
manufacturer's warranty null and void.
Tenacta Group S.p.A. Via Piemonte 5/11 24052 Azzano S. Paolo (BG) ITALY
16
The impurities or chemical
substances found in the water
have deposited on the plate.
You are ironing at a temperature
that is too high.
An excessive amount of limescale
and minerals has accumulated in
the boiler.
The ECO button (3) was not held
down long enough.
The cleaning cap (11) has not
been tightened properly.
Sometimes patches remain wet after
being steam ironed as the steam
condenses on the ironing board.
Pass the iron a number of times on
the wet patches without dispensing
steam. If the lower part of the ironing
board is wet, dry it with a dry cloth.
The iron has been designed to be
set horizontally.

DISPOSAL

ASSISTANCE AND WARRANTY

www. imetec.com
Tel. +39.035.688.111 Fax +39.035.320.149
Wait for the plate to cool down and clean
it with a damp cloth.
Wait for the plate to cool down and clean
it with a damp cloth.
Clean the boiler (see the CLEANING
THE BOILER chapter).
Hold the ECO button (3) down until the
boiler cleaning LED (6) goes off.
Make sure the cleaning cap (11) is
tightened well.
Use a mesh ironing board to prevent the
steam from condensing on the ironing
board.
Place the iron on the heat resistant mat.