Auto Redial; Line Identification - NEC N400i Mode D'emploi

No. Call diversion edit options menu
3 Disable all
4 Phonebook
5 Add to phonebook Adds the number to the phonebook as a new personal data or saves the number in an existing personal data.
Depending on the conditions, some options may be displayed in gray and not be available.
Call waiting and holding
This facility informs you that another call is being made to your phone while an existing call is in progress.
Setting up call waiting
☛
With the Calls screen displayed, press 2 to display the Call waiting screen.
☛
Press 1 and 1 to activate, or press 1 and 2 to deactivate the call waiting.
Press 2 to check the status of call waiting.
Using call waiting
☛
If you are on a call and another comes in, you will be alerted by a beep in the earpiece. Press Softkey 1 to put the current call on hold.
☛
Press Softkey 1 to accept the incoming call.
If you wish to switch the calls, press Softkey 1.
If you wish to merge calls, press Softkey 2 (see "Multi-party calls" on page 7).
☛
Press to end the current call, and then press Softkey 1 to retrieve the held call.

Auto redial

With the auto redial facility, your phone will redial a number up to 10 times if the first attempt fails. A tone will be heard at each redial attempt. Your phone
cannot connect a call if the other party is busy or if there are network problems. Pressing Softkey 2 during a redial attempt will abort it. To set redial on
or off, use the following procedure.
☛
With the Calls screen displayed, press 3 to display the Auto redial screen.
☛
Press 1 to activate or press 2 to deactivate the auto redial facility.

Line identification

The line identification facility is network dependent.
The line identification facility enables you to choose whether or not to send your own phone number when you make a call and also whether or not to
display a caller's phone number when you receive a call. To set line identification, use the following procedure.
11
Disables all fields.
Inserts a phone number in the edit field.