Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
5. SENSORS INSTALLATION
The position sensor is shown on the diagrams against. A drilling tool (hole saw) is provided with the product.
We advise you to protect the bumper of an adhesive (adhesive type painter) to avoid damaging the bumper when drilling. A light sanding of the edges of
the hole may be necessary after drilling.
The sensors must have at least one axis parallel to the ground is 90 ° to 95 ° depending on the perpendicular to the bumper.
The space between the sensors must be allocated and aesthetics, please follow the following schema data page for positioning sensors.
The ultrasonic sensors have a signal
and a scope as defined below cons.
0
40
80
0
40
80
16
2
Publicité
Chapitres
Table des Matières
