Before Installation - Beeper RE01AV/4 Manuel D'installation

1. BEFORE INSTALLATION

Warning
• The parking sensors front is an information tool, vehicle security and people near it is the driver's responsibility only. The driver must look if obstacles or people are near the
vehicle. Our responsibility can not be engaged in case of collision.
• The ultrasonic sensors radar physical limits of detection, some obstacles may be invisible or poorly detected:
• Objects of low heights <30 cm
• Corner wall not allowing the reflection signal highlights
• Obstacles such as towbars, bullbars, protection, ... another vehicle
• Objects that do not allow a good reflection of the ultrasonic signal: bicycle wheel, cloth ...
• Humans are detected within one meter of the vehicle
Thank you to the following tips before installing the system:
• The system runs on 12V DC voltage (12 V DC). Be sure the polarity of each wire.
• Before installation, if all elements of the car are working properly as contact & engine start, ignition codes, lights and headlights, turn signals, heating, air conditioning, power
door locks, ... Check after installing all these elements work.
• When you connect the general MASS system, it is very important that this mass is completely open and stable (no leaks).
• Ensure that all son passing through tight places are protected by adhesive tape to avoid excessive twisting and degradation of plastic wire protection with risk of bad contacts.
• Use a digital multimeter to identify each of the polarities of the son.
• Do not disconnect the battery if the vehicle has a car radio code.
• If the vehicle is equipped with an AIRBAG, do not disconnect the car battery or to connect without certainty son.
• Remove the fuse ceiling when installing the system to prevent battery drain (open).
CANBUS VEHICLES - The system is compatible with multiplexed vehicles. All the information needed to connect to son are on normal polarity (+ or -) of which does not pass
coded information (multiplexed CANBUS, VAN or other coding). You do not necessarily have to cut or touch a multiplexed thread. IN ALL CASES, IT IS USELESS AND RECOMMENDED
CUTTING WIRE ORIGINAL VEHICLE. YOU MUST ONLY MAKE A SPLICE AND RECOVER THE SIGNAL POSITIVE OR NEGATIVE HANDLED BY THIS THREAD. For further information or advice, we
ask you to contact our technical services 0,892,690,792 (€ 0.34 / min.)
2 13