After Installing This Navigation System - Pioneer AVIC-HD3 Mode D'emploi

After Installing this Navigation System

1. Reconnecting the battery.
First, double-check that all connections are correct and that this navigation system is
installed correctly. Reassemble all vehicle components that you previously removed. Then
reconnect the negative (–) cable to the negative (–) terminal of the battery.
2. Start the engine.
3. Press the RESET button on the navigation unit.
Press the RESET button on the navigation system using a pointed object such as the tip of
a pen.
4. Enter the following settings:
1. Make any necessary installation angle adjustments. (Refer to "Correcting the installation
angle" in "Chapter 9" of the Operation Manual.)
2. Change "Regional Settings" if necessary. (Refer to "Customising the Regional Settings"
in "Chapter 9" of the Operation Manual.)
3. Drive until the initialised sensors start operating normally.
Set the navigation system as explained in the Operation Manual or Hardware Manual.
After installing this navigation system, be sure to check at a safe place that the vehi-
cle is performing normally.
29