For Avic-Z120Bt Users; Installing This Navigation System; Installation Notes - Pioneer AVIC-Z120BT Manuel D'installation

Installation

For AVIC-Z120BT users

! Do not install this navigation system in a
position where the opening of the LCD
panel is obstructed by any obstacles, such
as the shift lever. Before installing this navi-
gation system, be sure to leave sufficient
space so that the LCD panel does not ob-
struct the shift lever when it is fully opened.
This may cause interference with the shift
lever, or a malfunction of the mechanism of
this navigation system.
Installing this navigation
system

Installation notes

! Do not install this navigation system in
places where it may become subject to
high temperatures or humidity, such as:
— Places close to a heater, vent or air con-
ditioner.
— Places exposed to direct sunlight, such
as on top of the dashboard.
— Places that may be splashed by rain, for
example close to the door.
! Install this navigation system in an area
strong enough to bear its weight. Choose a
position where this navigation system can
be firmly installed, and install it securely. If
this navigation system is not securely in-
stalled, the current location of the vehicle
cannot be displayed correctly.
! Install the navigation unit horizontally on a
surface within 0 degrees to 30 degrees tol-
erance (within 5 degrees to the left or
right). Improper installation of the unit with
the surface tilted more than these toler-
ances increases the potential for errors in
the location display, and might otherwise
cause reduced display performance.
30°
5°
! When installing, to ensure proper heat dis-
persal when using this unit, make sure you
leave ample space behind the rear panel
and wrap any loose cables so they are not
blocking the vents.
5 cm (2 in.)
10 cm (3-7/8 in.)
Section
5°
Dashboard
Leave ample space
21
En
04