Replace Odour/Fine Particle Filter Signal - Atag WS9111MRL Mode D'emploi

OPERATION

Replace odour/fine particle filter signal

EN 10
• If you switch on the cooker hood and the number '2' flashes on
the display, the odour/fine particle filter needs to be replaced. This
message will appear when the cooker hood has been in operation
for 320 hours. See 'Maintenance' chapter. Once you have installed
the new filter, you can switch off the signal by pressing the on/off
button for at least three seconds.
▷ If the grease filters also need to be cleaned, the numbers '1' and
'2' will flash alternately. In that case, the procedure for switching
off the signal will have to be carried out twice.
• If you want the signal to reappear the next time you need to replace
the odour/fine particle filter, you must reactivate the signal; switch
off the cooker hood with the on/off button and then simultaneously
press the fan button and the light button for at least three seconds.
▷ The numbers '1' and '2' will flash on the display for two seconds.
The signal to replace the odour/fine particle filter will then
reappear the next time.
• If you do not want the signal to appear the next time you need
to replace the odour/fine particle filter, you must deactivate the
signal; switch off the cooker hood with the on/off button and then
simultaneously press the fan button and the light button for at least
three seconds.
▷ The number '1' will flash on the display for two seconds. The
signal to replace the odour/fine particle filter will no longer
appear.