Timer Control; Charging A Usb Device; Cleaning; Cleaning The Housing - Tronic TLGL 1000 B1 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Timer control

This battery charger has a timer control which automatically switches over to
retention charging after 17 hours. This serves as an additional protection against
overcharging should the charge termination not respond due to a possibly defec-
tive battery.

Charging a USB device

Important
Ensure that the power consumption of the USB device is not higher than
1000 mA. For more information, refer to the instruction manual of your
USB device.
Insert the USB connector of the USB device into the USB output
battery charger.
If necessary, switch the USB device on.
notICE
You can simultaneously charge batteries in the battery charger and a USB
device at the USB output
ies is thereby halved and the charging process thus takes somewhat longer.

Cleaning

DAnger
Always remove the plug before cleaning the device. There is the risk of an
electric shock!.
When you are cleaning the device ensure that no moisture gets inside it, so
as to avoid irreparable damage to it.
Important
Do not use aggressive or abrasive cleaning agents, as these can damage
the upper surfaces.

Cleaning the housing

Clean the surfaces of the device with a soft, dry cloth. For stubborn soiling
use a lightly moistened cloth.
Never clean the insides of the charging slots with moist cloths. Instead, use
a clean soft brush to clean them.
If soiled, clean the charging contacts with a dry cloth.
TLGL 1000 B1
. Be aware that the charging current for the batter-
3
of the
3
GB │ IE
 9

Publicité

Table des Matières
loading

Table des Matières