Correct Weighing - Seca 799 Mode D'emploi Et Garantie

Correct weighing

– Press the Start key with no load on the
scale.
se(A 8. 8 . 8 . 8 . 8 .
, and
utively in the display. The scale is then
automatically set to zero and ready to
use.
– If necessary, switch the weight display
(see page 20).
– Stand on the scale and keep still.
– Read the weighing result off the digital
display.
– If a load greater than 150 kg or 200 kg
is placed on the scale,
the display.
– To switch off the scale, press the Start
key again.
Switching the weighing range
The seca 799 has two weighing ranges which can be selected. Weighing range 1 has a
reduced maximum capacity but greater display resolution, whilst weighing range 2 allows
you to use the maximum load capacity of the scale. Depending on the application in ques-
tion, you decide whether you would prefer to use the fine display resolution or the high
load range.
– Switch on the scale at the green Start
key. The scale initially operates in the
weighing range last selected.
– To change the weighing range, press
the key
– The weighing range active in each case
is shown in the display.
Note:
It is possible to switch from Range 1 with fine graduations to Range 2 with coarse grad-
uations with a load on the scale unless the scale is switched to a special function (like BMI,
for example). For technical reasons, it is only possible to switch from coarse Range 2 to
fine Range 1 with no load on the scale. In this case too, no special function may be acti-
vated.
20
0. 0
appear consec-
St0P
appears in