Steam Ironing - SilverCrest SDBS 2400 A1 Mode D'emploi

Steam ironing

1) Press the On/Off button
integrated in the On/Off button
lamp
2) Turn the temperature control
temperature control
3) The heat-up indicator lamp
up indicator lamp
4) Press the steam strength
–
If the "max" steam indicator lamp
produced.
–
If the "eco" indicator lamp
As soon as the "eco"
(depending on the setting) you can start steam ironing.
5) While you are ironing, you can now press and hold the steam button
continuously spray steam onto the goods to be ironed from the sole of the
iron
NOTE
When you press the steam button
issued from the sole of the iron
6) Put the iron down on the base station placement area
Set the temperature control
7) Press the On/Off button
integrated in the On/Off button
indicator lamps (depending on setting) will go out.
8) Disconnect the plug from the mains socket.
SDBS 2400 A1
to turn the appliance on. The indicator lamp
flashes.
must be set to a minimum of
goes out, the set temperature has been reached.
or "max"
. Release the steam button
to turn the appliance off. The indicator lamp
lights up and the "max" steam indicator
to set the required ironing temperature. The
lights up during heating. As soon as the heat-
button to set the required steam strength:
is lit up, a lot of steam will be
is lit up, less steam will be produced.
indicator lamps light up continuously
to stop producing steam.
, it can take a few seconds until steam is
.
to "min".
and the "eco"
to produce steam.
to
after ironing.
or "max" steam
GB │ IE 35 ■
│