Descaling; Storage - SilverCrest SSVS 1000 A1 Mode D'emploi Et Consignes De Sécurité

Clean all exterior surfaces and the mains cable
ened cloth after every use. Always dry the appliance properly before using
it again. Ensure that there is no detergent residue on or in the appliance
before using it again.
In the case of heavier soiling, put the appliance into a suitable pot, bearing
in mind the information found in Section Preparing the appliance, fill
the pot with water and measure the quantity used. The water level must be
on the "Max" marking.
Program an operating process with 65°C and a time of 10 minutes once
the target temperature is reached.
For every 4 litres of used water, add 1/2 table spoon of non-foaming liquid
dishwashing detergent into the water.
Start the operating process. After it has ended, disconnect the plug and
allow the appliance to cool down. As the last step, rinse the appliance
under cold running water. Before stowing it away, thoroughly dry off the
appliance.

Descaling

If you use the appliance frequently, you should descale it once per month. In
regions where the tap water has an above-average hardness level, descaling at
shorter intervals may also be warranted.
Proceed as follows for descaling:
Put the appliance into a suitable pot, bearing in mind the information found
in Section Preparing the appliance, fill the pot with water and measure
the quantity used. The water level must be on the "Max" marking.
Program an operating process with 80°C and a time of 20 minutes once
the target temperature is reached.
For every 4 litres of used water, add 1/4 table cup of citric acid powder
into the water.
Start the operating process. After it has ended, disconnect the plug and
allow the appliance to cool down. As the last step, rinse the appliance
under cold running water. Before stowing it away, thoroughly dry off the
appliance.

Storage

Let the appliance cool down completely before putting it away.
Store the appliance in a dry location.
SSVS 1000 A1
with a slightly damp-
31
GB│IE
│
■