Tractel pal-turn Notice D'utilisation page 21

Lower attachment (Option)
It is important to make sure that the load to be hung underneath pal-turn™ does not exceed its
capacity.
The general warnings on the 1
Always remove the accessories hung under the anchoring point, when the device is used as load
turner.
The lower attachment system fits inside the pal-turn™ so as to be able to place the latter on the floor
or any other stable surface.
Example : pal-
®
turn 1t
Lifting points (Option)
Loads can be lifted attached to lifting points –
fixed or adjustable – on the turner bar, without
laying pal-turn™ down. Accessories (slings,
hooks...) hung to these points with shackles have
to be removed for turning over.
These points loading constraints are identical to
descriptions on Figure 3 and Figure 4 page 19.
M 6067 M
rev 9 – 06/2020
GB
page are also valid for the lower attachment system.
st
Light signal
Lower
attachment
Pulley
Lifting
point
Page 21/90
www.tractel.com