Bosch HIIP054 Manuel D'utilisation page 44

Cooktop Problem
The display flashes (no
power) when you place
a pan on an induction
element
The SpeedBoost func-
tion display flashes and
then turnes off
"
Display and numbers
Display " and numbers
+
"§ š
+ number /
¡
number / + number
"‹ "Š
/
"ƒ
"...
"†
+ power level and
beep
"†
and beep
—‚
—ƒ —„
/
* If the warning persists call the Technical Assistance Service.
Do not rest hot pans on the control panel.
English 41
The pan is not ferromagnetic
The diameter of the pan is too small.
The element is too hot.
A fault in the electronic system has
occurred.
A fault has been detected.
Electronic system malfunction.
There is an internal operating error.
The electronic system has overheated
and the corresponding burner has
been turned off.
The electronic system has overheated
and all burners have been turned off.
There is a hot pan on the control
panel. It is highly likely that the elec-
tronic system will overheat.
There is a hot pan on the control
panel. The burner has turned off to
protect the electronic system.
Incorrect supply voltage, outside nor-
mal operating limits.
The burner has overheated and has
turned off in order to protect its cook-
ing surface.
Possible Causes and Suggested Solutions
Check the bottom of the pan with a magnet.
Use a pan with an appropriate diameter for the ele-
ment.
If the display still does not light up when you turn
the element off and on again, disconnect the appli-
ance at the circuit breaker. Wait 20 seconds and
then reconnect it.
The SpeedBoost function operates the element
with the highest possible power. During long cook-
ing times, it is possible that the function will turn the
element off to protect the cooktop from overheat-
ing. You can continue to use the cooktop if the dis-
play is not flashing.
Turn the appliance off and back on at the fuse or
ciruit breaker. If the same fault occurs again, dis-
connect the appliance and call Technical Assis-
tance Service.
The following table of error messages lists actions
you can take to correct the problem.
Unplug the cooktop from the mains. Wait about
30 seconds before plugging it in again.*
Unplug the cooktop from the mains. Wait about
30 seconds before plugging it in again.*
Wait until the electronic system has cooled down
sufficiently. Then touch any symbol on the cooktop.
*
Remove that pan. The malfunction indicator will
turn off shortly afterwards. You can carry on cook-
ing.
Remove that pan. Wait a few seconds. Touch any
key on the control panel. When the malfunction
indicator turns off, you can carry on cooking.
Contact your electricity distributor.
Wait until the electronic system has cooled down
sufficiently before turning it back on.