Installation; Mounting The Aircraft Panel Connector - Bose A20 Notice D'utilisation

Mounting the aircraft panel connector

The aircraft panel connector is part of the optional 6-pin wiring harness assembly.
Visit www.Bose.com or www.global.Bose.com for information or purchase.
Warning: The aircraft panel connector must be mounted by a technician who is
qualified to perform this type of avionics installation for the aircraft you
are using.
Mount the connector into a cutout, using the diagrams below as a guide.
12.5mm
.49"
Connect the eight wires as follows:
• Two for the microphone
• Two for audio
• One for power
• One for ground
• Two for audio shields
Audio and microphone wires should be connected to the back of the existing
microphone and headphone jacks, leaving existing jacks intact for use with
conventional headsets. This is usually the fastest installation method.
Receptacle - Pinout (front view)
Pin 6
14.0mm
.55"
Pin 1
Aircraft Interface Schematic
RED
BLK
WHT
BLU
WHT
WH/BLU

Installation

• 1 V+IN
• 2 GND
BLK/WH
• 3 COMM L
• 4 COMM R
• 5 MIC HI
• 6 MIC LO
BLK/WH
English - 35