Additional Handle; N : 4000-14000 Min; Installation And Setting - Meister MES480-1 Traduction Du Manuel D'utilisation Original

5457200-Exzentersc_man 27.03.15 09:58 Seite 40
MES480-1
5457200
Bj.
SN
230 V~/50 Hz Voltage and frequency
480 W
n : 4000–
0
-1
14000 min
Do not dispose of with the
household waste!
Address of the manufacturer
Meister Werkzeuge GmbH · Oberkamper Str. 37–39
D-42349 Wuppertal · Germany
Safety marks
Pay attention to the safety marks! The
symbols have the following meanings:
Wear safety goggles!
Read the operating
instructions!
Wear ear defenders!
Always work with a dust
collection system connected!
Double insulated!
40
Model designation
Article number
Year of construction
Series number
Max. power consumption
Revolutions in idle
"geprüfte Sicherheit" seal
of quality (tested safety)
CE mark (conformity with
European safety
standards)
7 – Installation and setting
Revolution regulation/Revolution
pre-selection function (Figure 1)
The machine has an electronic function
for controlling the revolutions. Activating
the switch (1) enables continuous
modification of the revolutions within the
specified values, for example, to enable
a gentle start.
The adjustment wheel (8) for pre-
selecting the revolutions allows you to
select the revolutions suitable for the
material in question, (+) = increases the
revolutions, (–) = decreases the
revolutions.
Additional handle (Figure 2)
The additional handle (7) serves to
ensure safe handling and guidance of
the machine during sanding. The handle
can be smoothly adjusted to the most
practical position for working. Turn the
wing screw on the additional handle to
the left to loosen, move the handle to
the required position, then tighten the
screw by turning to the right.
Attaching the sandpaper (Figure 3)
CAUTION! Switch off the
machine, disconnect the power.
The sanding plate is fitted with a hook
and loop system for sanding sheets.
This enables rapid application of new
sheets without the need for a tensioning
system. Before applying a new sheet,
tap the dust from the hook and loop
fastening of the sanding plate. Stretch
the sandpaper taut over the sanding
plate (6) and ensure that the dust
extraction holes of the sanding plate
and discs match up.