Wall Bracket - Airwell SX 18 Notice Technique

COOLING ONLY / HEATPUMP MODELS
CONDENSING TRAY
C

WALL BRACKET

D
A B
(accessory)
- The sheet metal bottom plate of the Condensing Unit
is punched under the cooling exchanger to allow
direct draining of condensate water.
- Connect the drain pipe with the hole of the tray
(Ø 20/27).
- Respect a slope of 2.5 cm/m in the flow direction of
the water.
Nota :
If you don't use the tray, heighten the Condensing Unit
to avoid ice to pile up.
PERÇAGE
A
DRILLIN G
34
B C D