Airwell SX 18 Notice Technique page 3

Masquer les pouces Voir aussi pour SX 18:
Table des Matières

Publicité

" When the HCFC fluids are replaced, these appliance have been optimized to operate
with the R-407C coolant which contains no chlorine and has no effect on the ozone layer."
MS 1040 F
MS 1040 RCF
MS 1400 F
MS 1400 RCF
- Gain de place à l'extérieur :
INTRODUCTION
The Multisplit system provides independent air
conditioning for two different rooms using the same
condensing unit.
This system controls each room individually, avoiding
the use of several outdoor units or centralized installa-
tions with air distribution through a duct network.
The Multisplit condensign untis are especially
designed to use the following 2 versions of standard
appliances :
• Cooling only - heatpump
B2
SX 18
A2
B1
or
SX 18
A1
B2
SX 24
A2
B1
or
SX 24
A1
Refer to the corresponding technical manuals for in-
formation about these appliances :
Modèles
Références Notice Technique
Models
References Technical Manual
An attractive look, a low sound level, requiring a small
floorspace, and an important range of well designed
accessories are the strong points of this range.
1. GENERAL
The Multisplit-system condensing units allow
to connnect 2 air treatment units to a single outdoor
condensing unit.
The condensing unit groups together all the
electrical and cooling components and provides di-
rect interfacing with indoor ST's.
2. ADVANTAGES
- Saving room outside :
only one outdoor condensing unit requiring a small
floorspace for connection with 2 indoor units.
3
K 18 A
GTW 18 F
or
K 18 A
GTW 18 F
K 24 A
GTW 24 F
or
K 24 A
GTW 24 F

Publicité

Table des Matières
loading

Table des Matières