Electrical Connection; Adjustments - Femi 504B Mode D'emploi Pour L'utilisation Et L'entretien

EN
2.6.

ELECTRICAL CONNECTION

Safety Standards for electrical connections
- Check that the mains system to which the machine is to be connected is earthed in
accordance with the relative safety regulations in force.
DANGER - WARNING
CHECK THAT THE POWER SUPPLY SYSTEM IS EQUIPPED WITH A THERMOMAGNETIC
CIRCUIT BREAKER TO PROTECT ALL CONDUCTORS FROM SHORT CIRCUIT AND
OVERLOADS (SEE APPENDIX).
Preliminary tests and checks after connection
DANGER - WARNING
- BEFORE CONNECTING THE MACHINE TO THE MAINS, CHECK THAT THE SUPPLY
VOLTAGE MATCHES THE VOLTAGE INDICATED ON THE MACHINE ITSELF.
- TO AVOID ANY POSSIBLE RESIDUAL RISKS OF TRIPPING AND FALLING, MAKE
SURE THAT THE POWER SUPPLY CABLE LIES COMPLETELY ON THE GROUND
AND IS NOT AT ANY POINT RAISED IN THE AIR.
Specific characteristics of the electrical system
DANGER - WARNING
- THE MACHINE'S ELECTRICAL SYSTEM IS FITTED WITH A DEVICE WHICH
PREVENTS AUTOMATIC RESET OF OPERATING CONDITIONS WHEN THE POWER
SUPPLY IS SWITCHED BACK ON AFTER AN INTERRUPTION.
- SHOULD THE MACHINE SUDDENLY CUT OUT THERE IS NO CAUSE FOR ALARM.
CHECK THAT THERE HAS NOT BEEN A VOLTAGE FAILURE IN THE MAINS
SUPPLY.

3. ADJUSTMENTS

DANGER - WARNING
- PLACE THE MACHINE IN SAFETY CONDITIONS, SEE HEADING 1.4.
- ALL THE PROCEDURES FOR MACHINE ADJUSTMENTS AND USE DESCRIBED
IN THE FOLLOWING HEADINGS MUST BE PERFORMED ONLY AFTER THIS
INSTRUCTION, USE AND MAINTENANCE MANUAL HAS BEEN READ AND
UNDERSTOOD IN FULL.
Before commencing work adjust the adjustable guards (O) or (D) based on the size of the
workpiece being handled.
- Slacken the knobs (P),
- To stop hands accidentally coming into contact with the belt/disc, make sure that the belt
or disc zone is uncovered only as much as is necessary for handling the workpiece.
- Block the adjustable guards (O) or (D) by tightening the knobs (P).
28