Electrical Connections; Electrical Connection; Instructions For Earthing - Femi TS 36-523 8.45.00.25 Manuel D'instructions

ELECTRICAL CONNECTION

Use 230 V 50 Hz alternate voltage equipped with a earthing conductor to supply your machine. Ensure that the
power supply corresponds to this voltage, that it is protected by a differential and magnetothermal switch, and that
the earthing system is efficient. If your machine does not work when connected to a socket, check carefully the
power supply features.
WHEN YOU ARE USING THE MILLER, YOU MUST ABSOLUTELY USE THE POWER
SUPPLY DEVICE PROVIDED WITH THE MILLER KIT. THIS POWER SUPPLY ALLOWS YOU
TO START THE SAW OR THE MILLER INDEPENDENTLY.

INSTRUCTIONS FOR EARTHING

Socket with earthing system
In the event of a tool functioning fault or short circuit, the earth connection provides the path of least resistance for
the electrical current and reduces the risk of electrical discharge. This tool is fitted with an electric cable which
includes an earth conductor and a plug with a protective earth contact. The plug must be connected to a correctly
installed socket and earthed in compliance with local standards and regulations. Be sure that your earthing system
is in good conditions and that your plug is protected by a differential and magnetothermal switch.
Do not modify the plug supplied on the tool. If it does not fit into the socket available have a suitable socket
installed by a qualified electrician. A faulty connection of the tool's earth conductor cay lead to the risk of electric
discharge. The earth conductor has a green (with or without yellow stripe) insulating sheath to distinguish it from
the others. Should the power cable ever need repairing or replacing, do not connect the earth conductor to a live
terminal.
If you fail to fully comprehend or have any doubts whatsoever concerning the earthing instructions, contact a
qualified electrician or maintenance technician.
If the power cable is damaged it must be replaced by an authorized assistance centre or qualified personnel.
NEVER switch the tool on if the power cable is damaged.
This tool is provided with a plug which must connected to a suitable socket.
EN

ELECTRICAL CONNECTIONS

Earth conductor
Machine's plug
31