X85; „ Heating; X85; „ Enter Code; Troubleshooting; Installation - Stiebel Eltron FET Utilisation Et Installation

INSTALLATION

Troubleshooting

RELATIVE HUMIDITY CORRECTION
… …„
Note
Set this parameter when the remote control's humidity
sensor is not measuring the relative humidity correctly
due to the installation location.
Select RELATIVE HuMIdITY CORRECTION to correct the dis-
played relative humidity by +/-5 %.
f use the Touch-Wheel to set the required correction. Con- f
firm with "OK".
TOUCH SENSITIVITY
… …„
Via TOuCH SENSITIVITY, your qualified contractor can adjust
the touch sensitivity of the Touch-Wheel and sensor keys.
HEATING
… „
COMFORT
… …„
Select COMFORT to adjust the set room temperature for com-
fort mode. If the heat pump is in comfort mode (see PRO-
gRAMS / HEATINg PROgRAM), it heats the heating water to
the value selected here.
The comfort temperature is the set temperature for heating
while people are at home.
Changing the set room temperature results in a parallel shift
of the heating curve.
f use the Touch-Wheel to select the required set room tem-
f
perature. Confirm with "OK".
ECO TEMPERATURE
… …„
Select ECO TEMPERATuRE to adjust the set room tempera-
ture for ECO mode. If the heat pump is in ECO mode (see PRO-
gRAMS / HEATINg PROgRAM), it heats the heating water to
the value selected here.
The ECO temperature is the set temperature for heating while
people are not at home or are asleep.
Changing the set room temperature results in a parallel shift
of the heating curve.
f use the Touch-Wheel to select the required set room tem-
f
perature. Confirm with "OK".
INTERVAL
… …„
Select INTERVAL to adjust the interval during which the change
in room temperature from the start screen applies (see chapter
"Menu / Start screen").
f use the Touch-Wheel to set the required interval. Confirm
f
with "OK".
ENTER CODE
… „
Select ENTER COdE to enter the preselected code to enable
the locked menus for a certain interval.
f Select the corresponding digits using the Touch-Wheel. f
Confirm with "OK".
FET
6. Troubleshooting
If you cannot remedy the fault, contact your qualified contrac-
tor. To facilitate and speed up your request, provide the num-
ber from the type plate (000000-0000-000000).
INSTALLATION
7.

Safety

Only a qualified contractor should carry out installation, com-
missioning, maintenance and repair of the appliance.
7.1

General safety instructions

We guarantee trouble-free function and operational reliability
only if original accessories and spare parts intended for the
appliance are used.
7.2

Instructions, standards and regulations

Note
Observe all applicable national and regional regula-
tions and instructions.

8. Appliance description

The device is assigned to a heating circuit and can influence
the values of the assigned heating circuit.
In a heat pump system, up to five devices can be connected.
A maximum of three devices can be connected to the WPM
heat pump manager and a maximum of two devices can be
connected to the WPE heat pump extension.
8.1

Accessories

8.1.1 Required accessories
- WPM heat pump manager
9. Installation
9.1

Installation location

Observe the following installation location requirements to
ensure correct function.
f Fit the device to an internal wall, but not in a recess.
f
f Never cover the device with curtains, etc.
f
f Ensure the device is not directly exposed to external heat f
sources (e.g. the sun, central heating or a TV set).
f Avoid direct draughts coming from windows and doors.
f
| 19