Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
OPERATION
Menu
f Touch "MENu" or "OK" to switch to the SETTINgS menu.
f
The display shows a padlock symbol.
f Keep your finger on the Touch-Wheel. A circle appears.
f
f Swipe your finger around the Touch-Wheel to unlock the
f
menu. The menu structure is displayed.
HAUPTMENÜ
MAIN MENU
INFO
INFO ►
PROGRAMME
PROGRAMS ►
EINSTELLUNGEN
SETTINGS ►
ZURÜCK
BACK ►
f Swipe with your finger around a menu item where you
f
want to make adjustments.
„INFO
„
PROGRAMMING UNIT SOFTWARE
…
„
This menu item tells you the software version installed on your
device.
HEATING CIRCUIT
…
„
This menu item tells you which heating circuit your device is
set up for.
Note
The heating circuit was defined in the commissioning
wizard.
„PROGRAMS
„
HEATING PROGRAM
…
„
Select HEATINg PROgRAM to determine the times during
which heating to the comfort temperature should take place.
In the intervals in between, heating takes place to the ECO
temperature.
18 |
Note
Set temperatures can be adjusted on the device via
SETTINgS / HEATINg / COMFORT TEMPERATuRE and
ECO TEMPERATuRE or on the heat pump manager via
SETTINgS / HEATINg / HEATINg CIRCuIT / COMFORT
TEMPERATuRE and ECO TEMPERATuRE.
f Set the times for the heating program.
f
Note
A detailed description of how to set the time program
can be found in the operating instructions for the
WPM heat pump manager.
„SETTINGS
„
GENERAL
…
„
LANGUAGE
…
…„
Change the system language via LANguAgE.
f Select the required language using the Touch-Wheel.
f
Confirm with "OK".
CONTRAST
…
…„
Select CONTRAST to adjust the contrast of the display.
f use the Touch-Wheel to select the required contrast. Con-
f
firm with "OK".
BRIGHTNESS
…
…„
Select BRIgHTNESS to adjust the brightness of the display.
When you operate the device, the display is illuminated to the
set brightness.
f use the Touch-Wheel to set the required brightness. Con-
f
firm with "OK".
BRIGHTNESS OFF
…
…„
Select BRIgHTNESS OFF to adjust the brightness of the dis-
play. If you do not make any entries on the device for a certain
interval, the brightness of the display is reduced to the value
selected here.
f use the Touch-Wheel to set the required brightness. Con-
f
firm with "OK".
ROOM TEMPERATURE CORRECTION
…
…„
Note
Set this parameter when the remote control's temper-
ature sensor is not measuring the room temperature
correctly due to the installation location.
Select ROOM TEMPERATuRE CORRECTION to correct the dis-
played room temperature by +/-5 °C.
f use the Touch-Wheel to set the required correction. Con-
f
firm with "OK".
FET
Publicité
Chapitres
Table des Matières
Dépannage
