Menu; Program Menus; Start Screen - Stiebel Eltron FET Utilisation Et Installation

OPERATION

Menu

5. Menu
Note
If summer mode is active on the heat pump manager,
settings made at the FET remote control will not have
any effect.
5.1

Program menus

5.1.1 Start screen

On the start screen, you can adjust the room temperature for
the relevant room.
MON
Mo
22°
f Keep your finger on the Touch-Wheel. A circle appears
f
showing the currently set value.
20°
f Swipe your finger around the Touch-Wheel to adjust the
f
room temperature.
f Take your finger off the Touch-Wheel. The display shows f
the selected setting for a few seconds before switching
automatically to the start screen. The entry is saved.
Note
The room temperature is only changed temporarily.
Once the adjustable interval has expired, the room
temperature reverts to the value preset by the heat
pump manager.
f Set the interval via SETTINgS / SETTINgS / HEAT-
f
INg / INTERVAL.
Application
For short term temperature adjustments.
16 |
16.06.
16.06.
14°
. 5
5.1.2 ECO
In this menu, you can set heating operation and, under certain
circumstances, also dHW to setback mode for a specific inter-
val. The temperature for setback mode (ECO temperature) is set
by the heat pump manager (see SETTINgS / dHW / dHW TEM-
PERATuRES / ECO TEMPERATuRE in the heat pump manager).
Note
After a set interval of 3 days, setback mode also affects
dHW heating.
ECO
ECO
Off
Off
f use "MENu" or "OK" to switch to the ECO menu. The dis- f
play shows the currently set value.
f Keep your finger on the Touch-Wheel. A circle appears
f
showing the currently set value.
f Swipe your finger around the Touch-Wheel to adjust the
f
interval for setback mode. The first half of the wheel is for
adjusting the interval from OFF up to 24 hours. If you con-
tinue swiping around the Touch-Wheel, you can extend
the interval from 2 to up to 30 days.
f Take your finger off the Touch-Wheel. The display shows
f
the selected setting for a few seconds before switching
automatically to the relevant menu. The entry is saved.
Note
Once the interval has expired, heating and dHW are
operated according to the times set in the heat pump
manager (see PROgRAMS / HEATINg and PROgRAMS /
dHW in the heat pump manager).
Application
during prolonged periods of absence (e.g. holidays).
8
FET