Fronius Acctiva Easy 1202 Instructions De Service page 29

NOTE!
Danger from charging dry batteries (primary cells).
This can result in damage to property.
▶
Connecting/
disconnecting
the battery
Danger due to connecting or disconnecting the battery while the charger is con-
nected to the grid.
This can result in serious injury and damage to property due to short circuits and arcs.
▶
▶
Establish a connection as follows:
1
2
3
4
Danger due to incorrect battery disconnection sequence.
This can result in serious injury and damage to property due to short circuits and arcs.
▶
If using an on-board or system plug to connect the charging lead, steps 3 and 4 do not
apply. Instead, connect charging lead to a suitable on-board socket.
It is not permitted to use this charger to charge dry batteries (primary cells).
WARNING!
Before connecting/disconnecting the battery, disconnect the charger from the grid.
During operation, check that charging terminals and battery poles are properly con-
nected.
Unplug the device from the grid
Plug charging lead into charger connection socket
Connect (+) charging terminal to positive pole (red) on battery
Connect (-) charging terminal to negative pole (black) on the battery, or to vehicle
body (e.g. engine block) in the case of vehicle power supplies.
WARNING!
When disconnecting, it is imperative to follow the above instructions in the reverse
order to avoid short circuits and arcs.
29