Standard Battery Parameters - HITEC RDX2 Pro Notice D'utilisation

Warnings and Safety Notes
•
A battery that is non-rechargeable (these pose an explosion hazard)
•
A faulty or damaged battery
•
Batteries installed in a device or which are electrically linked to other components
•
Batteries that are not expressly stated by the manufacturer to be suitable for the currents
the charger delivers during the charge process
PLEASE BEAR IN MIND THE FOLLOWING POINTS BEFORE YOU COMMENCE CHARGING:
•
Did you select the appropriate program suitable for the type of battery you are charging?
•
Did you set up the adequate current for charging or discharging?
•
Have you checked the battery voltage? Lithium battery packs can be wired in parallel and in
series, i.e. a 2-cell pack can be 3.7V (in parallel) or 7.4V (in series).
•
Have you checked that all connections are firm and secure?
•
Make sure there are no intermittent contacts at any point in the circuit.

Standard Battery Parameters

LiPo
Nominal
3.7V/cell
Voltage
Max. Charge
4.2V/cell
Voltage
Storage
3.8V/cell
Voltage
Allowable Fast ≤ 1C
Charge
Min. Discharge
3.0-3.3V/cell
Voltage
WHEN ADJUSTING YOUR RDX2 PRO CHARGING PARAMETERS, BE SURE YOU
SELECT THE PROPER BATTERY TYPE AND CELL VOLTAGE FOR THE TYPE OF CELL
YOU ARE CHARGING. CHARGING BATTERIES WITH THE WRONG SETTINGS MAY
Warning
CAUSE THE CELLS TO BURST, CATCH FIRE OR EXPLODE.
LiPo HV LiIon
3.8V/cell 3.6V/cell
4.35V/cell 4.1V/cell
3.85V/cell 3.7V/cell
≤ 1C ≤ 1C
3.1-3.4V/cell 2.9-3.2V/cell
LiFe NiCd
3.3V/cell 1.2V/cell
3.6V/cell 1.5V/cell
3.3V/cell n/a
≤ 4C ≤ 1-2C
2.6-2.9V/cell 0.1-1.1V/cell
NiMH Pb
1.2V/cell 2.0V/cell
1.5V/cell 2.46V/cell
n/a n/a
≤ 1-2C ≤ 0.4C
0.1-1.1V/cell 1.8V/cell
5