Battery Memory Set & Call Out - HITEC RDX2 Pro Notice D'utilisation

Battery Memory Set and Call Out
The RDX2 Pro charger can store up to 20 different charge/discharge profiles (10 per channel). The stored
profiles can be recalled quickly without having to go through the setup process.
[BATT MEMORY 1]
A
ENTER SET ->
BATT TYPE
A
LIPo
BATT VOLTAGE
A
22.2V (6S)
*FLASHING
CHARGE CURRENT
A
DISCHG CURRENT
A
DISCHG VOLTAGE
A
3.0V/CELL
TVC=YOUR RISK!
A
SAVE PROGRAM
A
SAVE PROGRAM
A
SAVE....
[BATT MEMORY 1]
A
LiPo 22.2V (6S)
Lithium Packs: (LiPo, LiFe, LiIon, LiHV)
Press the MODE/STOP button to exit any charging programs
you are currently in and then SCROLL to the BATT MEMORY
program. Press the Jog Dial ENTER to enter the program.
SCROLL to select the memory #. Once set, the battery type and
voltage will be displayed. If not set, it will read ENTER SET.
Press the Jog Dial ENTER to set up a new memory. BATT TYPE
will be displayed, press ENTER to make it blink and then
SCROLL to select the Lithium battery you want to charge. Once
selected, press ENTER to store.
SCROLL to the right for BATT VOLTAGE, press ENTER to make
it blink and SCROLL to adjust. Once selected, press ENTER to
store. SCROLL to the right for CHARGE CURRENT, press ENTER
5.0A
to make it blink and SCROLL to adjust. Once selected, press
ENTER to store.
SCROLL to the right for DISCHG CURRENT, press ENTER to make
2.0A
it blink and SCROLL to adjust. Once selected, press ENTER to
store.
SCROLL to the right for DISCHG VOLTAGE, press ENTER to make
it blink and SCROLL to adjust. Once selected, press ENTER to
store.
SCROLL to the right for TVC=YOUR RISK!, press ENTER to make
it blink and SCROLL to adjust. Once selected, press ENTER to
4.20V
store.
ENTER
Warning
Finally, SCROLL to the right for SAVE PROGRAM, press ENTER to
store this memory.
Warning: Setting the TVC (Terminal Voltage
Cut Off) higher than the default is not
recommended. While it will increase the
output power slightly, the difference is
negligible, and it will degrade the life of
the pack.
25