HITEC RDX2 Pro Notice D'utilisation page 15

Operating the Charger
LiPo BALANCE
A
2.0A 11.1v (3S)
LiPo BALANCE
A
2.0A 11.1v (3S)
LiPo BALANCE
A
2.0A 11.1v (3S)
LiPo BALANCE
A
2.0A 11.1v (3S)
BATTERY CHECK
A
.............
R:3SER S:3SER
A
CONFIRM (Enter)
R:3SER S:3SER
A
CANCEL (STOP)
Charge MODE Select: Once you have selected the proper
battery type, SCROLL through the charge modes which include
Balance, Charge, Fast Charge, Storage & Discharge. It is highly
recommended to use the Balance mode to keep your packs
in the best condition. Instruction on how to use the most
common LiPo Balance mode is described below. If you plan to
use a different mode, the programming is identical.
BATTERY Setting: Once you have selected the Charge mode,
the amperage and voltage will be shown on the lower line.
These values will be what was entered previously or defaulted.
Tip
The first step is to set the amperage. Push the Jog Dial to
"ENTER" and the setting will start to blink. SCROLL clockwise
*FLASHING
to increase or counterclockwise to decrease the value and
press "ENTER" to confirm your setting. Note: As a general rule,
this value should be set to a 1C rate, meaning "1" multiplied
by the Capacity (I.E.: 2000mah = 2A). Once you confirm the
amperage setting, the cell count next to the voltage will start
to blink. SCROLL to change the value to the exact voltage/cell
count of your pack and press "ENTER" to confirm.
Program Start: Verify that these settings match the ratings on your
pack (I.E. 2000Mah =2A 11.1V = 3 Cells). Once confirmed, press and hold
the Jog Dial for 3 seconds to start. The charger will perform a quick check
to detect the number of cells. R shows the number of cells detected by the
charger while S is the number of cells set by the user. If the numbers are
not identical, press STOP to go back to the previous screen and recheck the
number of cells in the battery pack before proceeding. If correct, press the
Jog Dial "ENTER" to confirm and start the charging process.
Tip: If you are recharging the same pack, you
will not have to re-do these settings.
15