HITEC RDX2 Pro Notice D'utilisation page 26

Battery Memory Set and Call Out
NiMH/NiCd:
charging programs you are currently in and then SCROLL to the
BATT MEMORY program.
Press the Jog Dial ENTER to enter the program. SCROLL to
select the memory #. Once set, the battery type and voltage
will be displayed. If not set, it will read ENTER SET.
Press the Jog Dial ENTER to set up a new memory. BATT
TYPE will be displayed, press ENTER to make it blink and
then SCROLL to select the battery you want to charge. Once
selected, press ENTER to store.
SCROLL to the right for BATT VOLTAGE, press ENTER to make
it blink and SCROLL to adjust. Once selected, press ENTER to
store.
SCROLL to the right for CHARGE CURRENT, press ENTER to make
it blink and SCROLL to adjust. Once selected, press ENTER to
store.
SCROLL to the right for TRICKLE, press ENTER to make it blink
and SCROLL to adjust. Once selected, press ENTER to store.
SCROLL to the right for PEAK DELAY, press ENTER to make it
blink and SCROLL to adjust. Once selected, press ENTER to
store.
SCROLL to the right for DISCHG CURRENT, press ENTER to make
it blink and SCROLL to adjust. Once selected, press ENTER to
store.
SCROLL to the right for DISCHG VOLTAGE, press ENTER to make
it blink and SCROLL to adjust. Once selected, press ENTER to
store.
Finally, SCROLL to the right for SAVE PROGRAM, press ENTER to
store this memory.
26
Press the MODE/STOP button to exit any
[BATT MEMORY 1]
A
ENTER SET ->
BATT TYPE
A
NiMH
BATT VOLTAGE
A
7.2V (6S)
CHARGE CURRENT
A
5.0A
TRICKLE
A
100MA
PEAK DELAY
A
1MIN
DISCHARE CURRENT
A
2.0A
DISCHG VOLTAGE
A
1.0V/CELL
SAVE PROGRAM
A
ENTER
SAVE PROGRAM
A
SAVE....
[BATT MEMORY 1]
A
NiMH 7.2V (6S)
[BATT MEMORY 1]
A
C:2.0A D:1.0A
*FLASHING